Storage precautions for LED display screens

  Many times, we cannot install the LED display screen immediately after purchasing it due to some factors. In this case, it is necessary to store the LED display screen well. As a precision electronic product, the LED display screen has very high requirements for storage methods and environment. If you are not careful, the LED display screen may be damaged. Today, LISN LED will talk about how to properly store the LED display screen from the professional perspective of the LED display screen manufacturer.

  There are many types of display screens: outdoor, indoor; soft screen, hard screen; strip curtain, grille, etc., and the storage and protection methods are different.

  The following eight points should be noted when storing LED display screens:

1. The place where the box is to be placed needs to be cleaned and paved with pearl cotton.

   
   

   2. It is strictly forbidden to randomly stack modules or stack more than 10 modules on the LED display screen. When stacking modules, the lamp faces are placed oppositely and isolated with pearl cotton.

  3. It is recommended that the LED display screen box be placed flat with the lamp face facing up. If there are too many modules and they need to be placed upright, special attention should be paid to protection. It is forbidden to place them upright in places with large vibrations.

  4. The display screen box should be handled with care. When landing, the back side should land on the ground first and then the lamp face to prevent bumps.

  5. All staff must wear cordless anti-static wristbands when carrying or installing.

  6. The place where the LED display is stored should be kept as dry, ventilated and without sunlight as possible.

  7. When carrying the box, it should be lifted up and should not be pushed or dragged on the ground to avoid damage to the bottom module due to uneven ground. The box should be kept balanced during the lifting process, and should not swing left and right or rotate in the air. When installing the box or module, it should be handled with care, and throwing is strictly prohibited.

  8. If the LED display product needs to be adjusted, use a soft rubber hammer to hit the metal part of the box, and it is strictly prohibited to hit the module. It is strictly prohibited to squeeze or collide between modules. In the case of gaps, abnormal positioning, etc., it is strictly prohibited to use hard objects such as hammers to hit the box and module. You can pick up the box to remove foreign objects and try again